Starlink Replacement SPX Cable – 10m (32ft) for Gen 2 Terminal

Description

The Starlink Replacement SPX Cable – 10m (32ft) is a rugged, high-quality replacement cable designed specifically for the Starlink Gen 2 Standard Terminal. It’s ideal for shorter rooftop runs, wall-mounted installations, or when replacing a damaged cable without the bulk of an unnecessarily long lead.

Unlike most generic or even genuine Starlink cables—which use thinner 26AWG conductors—SpaceTek’s version uses 24AWG stranded copper to provide lower voltage drop, higher current capacity, and greater reliability over time. This makes it especially effective when used with DC injectors or off-grid Starlink power systems where efficiency is critical.

It features a UV-stable CMX outdoor-rated jacket, foil shielding with drain wire, and comes factory-fitted with the correct Starlink Gen 2 IP67 waterproof connector, ensuring easy plug-and-play installation.

⚠️ Only compatible with Starlink Gen 2 Standard Terminals. Not for use with Gen 3, Mini, or High Performance Starlink units.

Key Features

✅ 24AWG Stranded Copper Core – Stronger Than 26AWG

Thicker 24AWG wiring means less resistance, better power delivery, and more stability over distance—even at just 10 metres.

✅ Shielded & Weatherproof

Foil shielding with drain wire protects against interference. The CMX-rated outdoor jacket is UV resistant and ready for harsh Australian conditions.

✅ Starlink Gen 2 IP67 Connector

Genuine-style Starlink Gen 2 waterproof plug ensures a weather-tight seal with a positive click into the terminal—no need for adaptors or sealing.

✅ Shorter Length, Same Durability

Designed for tidy installs with just the right length—minimising cable mess while maintaining full shielding and performance.

Specifications

• Length: 10 metres (32 feet)

• Cable Type: Cat5e FTP (Foil Shielded Twisted Pair)

• Conductor: 24AWG stranded copper

• Jacket Rating: CMX Outdoor UV-Stable

• Shielding: Foil with drain wire

• Connector A: Starlink Gen 2 IP67 waterproof plug

• Connector B: Standard RJ45

• Temperature Rating: Up to 75°C

• Compatibility: Starlink Gen 2 Standard Terminal only

Installation Overview

1. Disconnect Power First – Always switch off the power before removing or installing the cable.

2. Unplug Old Cable – Remove the factory or damaged cable from both terminal and injector/router.

3. Install New Cable – Plug the IP67 connector into the terminal until it locks in place.

4. Route Carefully – Avoid sharp bends or high-abrasion contact points.

5. Reconnect Power – Restore power and confirm connectivity.

Important Notes

⚠️ Gen 2 Compatibility Only – Will not work with Starlink Gen 3, Mini, High Performance, or Gen 1 systems.
⚠️ Use Only with Proper Power Injectors – Standard RJ45 extension cables do not fit the Starlink Gen 2 port.
⚠️ Always Power the System Correctly – Connect the power source before turning on the terminal to avoid start-up issues.

Ideal Use Cases

✅ Shorter rooftop or shed-mounted installations
✅ Clean, low-clutter Starlink setups
✅ DC-powered off-grid systems using StarPower
✅ Harsh outdoor environments needing UV and water protection
✅ Caravan, 4WD, or marine installations

Compact, Reliable, and Purpose-Built

The 10m Starlink SPX Cable from SpaceTek is a no-compromise solution for Gen 2 users who want better-than-factory performance in a compact length. With 24AWG strength, full shielding, and waterproof reliability, it’s the perfect fit for shorter yet critical installs.

Need a longer version? Try the 23m cable for bigger setups or more distance flexibility.